Do you know at what depth a main distribution network should be buried? I see that the inspection chambers on offer aren’t very deep. Just so you know, I’ll only be going over it with a rototiller. Should I also add a network of conduit for the solenoid valve wires if they’re located at the entrance to each block?
Thanks a lot for any info or resource sites you might have to share.
Hello, a frost-free depth of 80 cm is ideal (if there’s enough soil). If one day you need to run a subsoiler through to decompact the soil, that’s more than enough. Better to plan for enough, because once it’s buried, it’s there for good. It’s possible to make branches with a T on the main line to create an outlet at the surface or in a shallow inspection chamber.
Ideally, run the electrical at the same time. Afterwards, there are solenoid valves with a timer from Rain Bird at €90 each. Much cheaper than running conduits and cables over long distances. We put an outlet with this type of solenoid valve on each garden, and this summer the time savings were monumental. You just need a board to note the watering schedules for the gardens, and you’re all set.
Thanks a lot Maël, I was thinking of getting a Rain Bird ESP ME3. You’re talking about battery-powered solenoid valves, each with its own controller, is that right?
@Philippe_Chevalier that’s the model we installed. Really handy for not having to work on Sundays anymore.
Yes, that’s right. One solenoid valve timer per zone. We have an antifreeze valve upstream (plus a pressure regulator and a pressure gauge for the GAG). That way, when we shut down for the winter or when it rains, we close the valve. A small cut-off container over the timers protects them from the weather.
@user55 wow, there’s a lot I don’t understand in this paragraph.
1 - So your battery-powered solenoid valves are controlled via Bluetooth by the Rainbird without any wired connection. I don’t get it: is the Rainbird a timer + timer-controlled solenoid valves? Two separate devices?
2 - At what level is the antifreeze valve installed? Is it a manual valve with a hole in the plug?
3 - What about the pressure regulator and gauge, what do you set them to? I was told that GAGs could withstand fairly high pressures… was I misinformed? I have between 2 and 3.7 bar in my system.
Sorry, it’s always complicated to put plans into writing.
1-each controller is on each solenoid valve. You have to go out to the garden to change the programs. Normally you go out there fairly regularly. It’s less convenient than a central station. But also cheaper in terms of cable and conduit.
2- the antifreeze valve is the first thing after your pipe coming out of the ground. These are valves that are supposed to open rather than burst when there’s frost. You still need to drain the system in case of freezing to be safe.
3-it all depends on the GAG. Here it’s t-tape so 0.5 bar. But each piece of equipment has its own specs.
There’s so much different equipment, irrigation is a real headache.
Thanks a lot. That’s not my situation — I have an above-ground pipe that comes from a hillside reservoir. So I have to purge the whole system.
I bought a new Rain Bird on Le Bon Coin, so I’m going to set up a central controller. I have a small garden, so there’s not much wiring. It should work out.